CFMoto 625 CForce
- ECU
- Bosch MSE6.0
- ECU maker
- Bosch
- Model years
- 2020-2023
- Stock firmware
- Included · 1.52 MB
What you can tune
20 calibration tables · 8 scalars · 2 patches & flags — all editable in the browser.
Getting started
Start from the included stock firmware, or upload your own BIN read.
Heat-mapped tables, editable 2D/3D graphs, cell math, AI auto-tune, and compare against other reads.
Download a standard modified BIN and flash it with your own hardware and software.
Calibration maps
| Map | Group | Tables |
|---|---|---|
| Volumetric efficiency | Fuel | 1 |
| Standardized air mass flow through throttle valve | Fuel | 1 |
| Nominal Lambda for component protection # | Fuel | 2 |
| Lambda at WOT | Fuel | 1 |
| Map for calculation of nominal charge | Fuel | 1 |
| Target Lambda at partial load | Fuel | 1 |
| Lambda during warm up by engine and coolant temperature | Fuel | 1 |
| Injection correction factor by effective injection time # | Fuel | 2 |
| Ignition advance-angle characteristic map | Ignition | 2 |
| Optimal Ignition advance-angle map # | Ignition | 2 |
| Ignition advance-angle correction by engine and coolant temperature | Ignition | 1 |
| Desired throttle angle | Throttle / ETV | 1 |
| Throttle position sensor | Throttle / ETV | 1 |
| Idle engine speed by engine temperature # | Idle | 2 |
| RPM Limiter 2 (H+R) | Limiters | 1 |
8 adjustable scalars (rev limits, thresholds, corrections)
| RPM Limiter 1 |
| RPM Limiter 1 |
| Lambda Limit for combustion |
| Speed Limiter 1 |
| Speed Limiter 2 |
| Speed Limiter - L |
| Speed Limiter - L |
| Speed Limiter - L |
2 patches & flags (toggle features on/off)
MotoEditor edits the calibration and exports a standard BIN — reading and flashing the ECU is handled by your own flashing hardware and software.
Frequently asked
What can I tune on the CFMoto 625 CForce 2020-2023?
This verified definition exposes 20 calibration tables — including fuel, ignition, throttle, limiters and idle maps — plus 8 adjustable scalars and 2 feature patches, all editable in your browser.
Do I need to remove or open the ECU?
No. MotoEditor edits the calibration and exports a standard BIN. Reading the stock file from the bike and writing it back is done with your own flashing hardware and software.
Which ECU does this CFMoto 625 CForce definition cover?
The Bosch MSE6.0 (Bosch). Every map address and scaling is verified against the stock firmware, so what you edit matches the real calibration.
Can I use my own stock file?
Yes. Start a project from your bike's stock BIN and your changes apply to it, or begin from the built-in reference — either way you export a standard BIN.
How much does access cost?
MotoEditor is a single subscription that unlocks the browser editor for this definition and every other bike in the library — no per-project or per-download fees.