Moto Morini X-Cape 650
- ECU
- Bosch MSE6.0
- ECU maker
- Bosch
- Model years
- 2022-2024
- Stock firmware
- Upload your own
What you can tune
20 calibration tables · 1 scalars · 0 patches & flags — all editable in the browser.
Getting started
Upload your own BIN read of this ECU to start from.
Heat-mapped tables, editable 2D/3D graphs, cell math, AI auto-tune, and compare against other reads.
Download a standard modified BIN and flash it with your own hardware and software.
Calibration maps
| Map | Group | Tables |
|---|---|---|
| Volumetric efficiency | Fuel | 1 |
| Standardized air mass flow through throttle valve | Fuel | 1 |
| Nominal Lambda for component protection # | Fuel | 2 |
| Lambda at WOT | Fuel | 1 |
| Map for calculation of nominal charge | Fuel | 1 |
| Target Lambda at partial load | Fuel | 1 |
| Injection correction factor by effective injection time # | Fuel | 4 |
| Ignition advance-angle characteristic map | Ignition | 1 |
| Optimal Ignition advance-angle map # | Ignition | 3 |
| Desired throttle angle | Throttle / ETV | 1 |
| Throttle position sensor | Throttle / ETV | 1 |
| Calculated exhaust gas temperature # | Air & Exhaust | 2 |
| Version | Other · Rom Info | 1 |
1 adjustable scalar (rev limits, thresholds, corrections)
| RPM Limiter |
MotoEditor edits the calibration and exports a standard BIN — reading and flashing the ECU is handled by your own flashing hardware and software.
Frequently asked
What can I tune on the Moto Morini X-Cape 650 2022-2024?
This verified definition exposes 20 calibration tables — including fuel, ignition, throttle, air & exhaust and other · rom info maps — plus 1 adjustable scalars and 0 feature patches, all editable in your browser.
Do I need to remove or open the ECU?
No. MotoEditor edits the calibration and exports a standard BIN. Reading the stock file from the bike and writing it back is done with your own flashing hardware and software.
Which ECU does this Moto Morini X-Cape 650 definition cover?
The Bosch MSE6.0 (Bosch). Every map address and scaling is verified against the stock firmware, so what you edit matches the real calibration.
Can I use my own stock file?
Yes. Start a project from your bike's stock BIN and your changes apply to it, or begin from the built-in reference — either way you export a standard BIN.
How much does access cost?
MotoEditor is a single subscription that unlocks the browser editor for this definition and every other bike in the library — no per-project or per-download fees.